Place nail just above the overlap.
How to nail channel cedar siding.
Face nail with two nails per piece for 8 inches patterns and wider keeping nails 2 1 2 to 3 inches apart to allow for dimensional movement without splitting.
In general each piece of siding must be nailed independently.
Allow a 1 8 in.
Patterns and wider keeping nails 2 1 2 to 3 in.
Apart to allow for dimensional movement without splitting see figure 6.
Use 15 felt paper behind it.
Good nails and nailing practices are a must in proper application of wood siding.
Do not nail through overlaps.
Nail locations are included under individual patterns.
Drive nails through the bottom of the board about 1.
Wide use one nail one inch up from the lap.
It s a truly beautiful option which is one reason why fiber cement siding is even commonly made to look like it too.
If you want to nail over the existing sheathing fur it out because the nails will not hold long term just to the plywood sheathing.
Requirements the following requirements are essential for nails used on ewp siding.
For siding up to 6 in.
The best technique is to nail the vertical cedar siding to 2x4 blocking so that the box galvanized nail penetrates 2 inches.
Maze nails are a good brand.
Galvanized hot dipped zinc coated and aluminum nails are all appropriate.
Expansion gap between pieces if the siding is air or kiln dried.
Siding should be fastened to each stud or furring strip with nails spaced at a maximum of 24 in.
The length of nail you use will depend on the thickness of the siding.
Allow a 1 8 inch expansion gap between pieces if the siding is air or kiln dried.
Always use corrosion resistant nails when working with cedar wood.
Both t g and bevelled siding gets a fastener 3 4 above the top of the board below.
Do not nail through overlaps.
However the following data about nails will be very helpful in the selection and use of the right nail for the right use.
Channel lap cedar siding cedar siding is perhaps the most common type of wood siding and also the one that the lap style is most commonly made out of as a consequence.
Face nail with two nails per bearing for 8 in.
Fasten the plank with galvanized ring shank nails long enough to penetrate the siding sheathing and into the wall studs at least 1 1 4 inch.
Nail placement depends on the siding pattern and width the key is to fasten the siding securely without preventing it from moving in response to the moisture content in the air.
Where possible the bottom of the board that is placed across the top of the windows should coincide with the window cap.
For siding up to 6 inches wide use one nail one inch up from the lap.
Bevel siding should be face nailed to studs with 1 1 4 inch penetration into solid wood using one nail per piece spaced at a maximum of 24 inches on center.
The idea is to avoid double nailing the board which will cause cracks when it shrinks.
