How To Nail Roof Jacks

Next drive a nail at the bottom part of the jack in order to secure it on both ends.

How to nail roof jacks.

Then the nail is pounded in and sealed. If you are new to working with roof brackets. Now you ve installed the first one. Use a ladder against a side of the building to climb to the roof edge.

Roof jacks provide a stable surface to work increasing safety and making it easier to apply roofing. Nail the cut off shingle into place about 6 inches from its lower edge. Step 1 check out the roof. Step 2 attach two jacks.

Make sure to keep nails out of the tar strip as you work. Make sure that you don t push it all the way inside your roof since you might damage it. Drive a nail in each slot and pound it down in such a way that it is level with the metal of the jack. The front end of the base goes under the shingle just above it and you drive a 3 inch nail through the hole at that end to secure it.

Ideally locate a rafter below the sheathing. If not you will need to break the tabbing cement and carefully lift the exposed part of the shingle insert the jack and nail using a wonder bar or something. Each jack has a flat base with a series of nail holes. Hammer in one nail about 2 inches from each end of each shingle and another nail about 1 inch above each cutout.

You can usually feel sheathing nails which are driven into rafters through the underlayment attach a jack by driving two 16d nails never roofing nails into a rafter. Roof jacks appear to be installed by lifting shingles and only creating nail holes under the shingle. So there is no exposed hole. Guide to installing roof brackets.