The roofing felt should be applied in layers that overlap.
How to place roof felt paper.
Roll out the tar paper along the.
A third layer of felt needs to be placed.
Continue pulling the felt tight.
Tack it in place at the corner with the end flush with the end of the roof and the bottom edge of the roll right along the bottom of the roof.
The idea is to make sure water that falls on the roof drips down from paper to paper and off the roof rather than up under the tar paper potentially damaging the roof s wooden structure.
Apply another layer of adhesive to the top for maximum waterproofing.
Attaching your roof felt 1.
Adjust the bottom of the felt if necessary to keep it flush with the gutter apron.
Tack the felt onto the initial rolling spot using a tack gun.
Step 3 overhang paper.
Start at the bottom of the roofline and work up so any water that gets through the roofing material will shed down the tar paper and will not go under it.
Allow for a inch overhang of paper down each side of the roof when unrolling the paper.
You will follow the same process as in step 2 for the last layer.
Place a final piece of tar paper over the top of the roof attaching it so it overlaps the tar paper on both sides of the roof.
Insert staples with a hammer stapler 12 inches apart along the top and bottom edges of the felt paper as you roll it out along the roof.
In fact there are a number of important ways roofing felt not only protects your roof but.
Roofing experts have discovered that adding a layer of protection between your structural roof decking the layer of wood that covers your rafters and your roof shingles helps create a better looking and longer lasting roof.
This overhang will ensure water will not enter underneath the paper getting trapped on top of the wood roof planks.
Begin at the bottom right or.
Begin your first row of tar paper with the bottom of the tar paper slightly hanging over the edge of the roof.
Why use roofing felt paper.
Start the roof felt at one bottom corner of the roof.
Use a ladder to reach the bottom level of the roof.
Start rolling the first layer of felt out from the bottom of one side of the roof.
Step 4 over the peak.
Start at the bottom edge of the roof and roll the paper roll out toward the peak.
Step 4 continue rolling out the felt until you reach the roof hip on the other end.