How To Pull Wire Through Wall

If the wall above runs parallel to the attic or basement joist this cable will be attached across the side of a joist.

How to pull wire through wall.

Attach the cable you want to pull on the wire leader this has a hook for the wire with a strong magnet attached. Make sure the tape is smooth so the cable can slide through the opening. Glow rods can also be used to hook wires to pull them out as a wire snake tool. Get expert advice on how to fish electrical wires through walls and ceilings with only a few common tools.

Slide the wire through the opening. From the attic or basement pull steadily on the fish tape while a helper feeds the cable into the wall opening. Pull the cable through with a fish tape. Roll out the cable through the basement or attic space to the next box location.

Fish the wire gently by pulling at short intervals on one end while your helper feeds more wire from the other end. Lubricating the wires. Be gentle as you fish the cable through the hole since it is important not to tear the sheathing on the cable. Wire pulling compound is a non conductive lubricant in either a gel or a slimy soapy form that makes both the conduit and wires slick by coating the wiring allowing.

Carefully extend the fish tape from one opening to the other. If you will need to fish wiring through a wall drill a hole through the wood plate in the attic only. Cut the cable leaving plenty of slack and feed the cut end into the wall cavity and out through the wall hole as you did with the first box. Tape the end of the fish tape tightly onto the cable with electrical tape.

When cutting through drywall from the interior of a room use a utility knife and cut carefully you don t want to drill through a hidden wire or the paper backing of the attic insulation. It may take some finessing as the tip of the fish tape blade passes through the drilled hole in the wall plate. Once your hole is drilled you can shove a glow rod through the hole to start fishing wire attach your wire to the eyelet at the end and pull it back through. Buy a bit that has a hole on the end of it so you can use the bit itself to pull wires.

Then retract the fish tape to pull the cable through. Running electrical wires allows you to add additio. You can push the wire leader with the cable attached toward the sheetrock or the side with the opening. It is easier to fish a new wire through a wall if you have someone on the other side to help you pull on the wire if anything happens.