How To Remove Siding Nails

Insert a pry bar between the piece of siding from which you want to remove the nails and the one above it.

How to remove siding nails.

When the head rises make a secure and tight hold on the head of the nail and create a sideway with a little bit pressure. If the siding is hard to remove try tapping it with the palm of your hand. Run the blade at a 45 degree angle just before the sidings nailhead. The job was to remove the metal siding without damaging it and reuse it for another building.

To pull each nail you first need to raise the head a small amount. Keep prying until the head rises from wood or other surfaces. Use a mallet or hammer to gently drive the tip of the bar up behind the siding if necessary. Unlock the course of siding above the tightly nailed piece sliding the unlocking tool along underneath the lap.

The best way to do that is to pound the pointed jaws of a cat s paw under the head. Slide the blade of a hacksaw. Lift the siding up and look for nails that have been hammered in too tightly. Press the upper siding board back against the wall leaving the popped nail heads accessible.

Set your hammer to the head of the nail and then pry it. Step 2 pry the piece of siding out toward you gently to let you see the nail or screw patterning of how the planks have been fastened to the under structure. Pull them out with a. If the piece still seems attached to the wall gently pull it outward so it comes free of the channel holding it in.

Loosen the tight nail or cut it with a hacksaw. Pry bars would dent the. Take your hammer and find out the nail you want to remove. It was installed with ring shank nails.

The force of the hammer is usually enough to. This will cutoff the head about a 1 4 inch below the.