How To Replace A Piece Of Hardiplank Siding

Just the nails that will prevent the new board from sliding back into place you can either completely remove the nails or clip them off.

How to replace a piece of hardiplank siding.

Once all the nails are removed from the adjoining board the damaged one should just pull out. Slide the thin edge of a flat pry bar carefully under the lower edge of the first piece of hardieplank siding to. Blind nail the fiber cement siding in place starting with the bottom piece. Then use a chalk line to create a reference mark for the first or bottom piece of siding and start securing the siding pieces from the bottom to the top.

This way water and other elements can t go past the patch between or behind the planks and cause further damage. Do not drive the nails flush or countersink them. A long piece of siding will sag in the middle so use temporary blocks to hold it in place while you attach it. Use a pry bar to remove the damaged siding.

Prime the back and edges of the new siding. Remove the nails in the corner cap. Remove the nails on the lap board then use the claw of the hammer to split the board down the center image 1. How to remove hardie plank step 1.

Thoroughly paint all exposed edges and grooves. Trim your replacement pieces down to size using the old siding for reference. The heads will break the paper face allowing water to soak in and deteriorate the siding. The best way to fix these gaps is to clean the joint and then patch it with caulk.

To remove and replace damaged siding. Cut the fiber cement siding to length wear approved dust protection. Placing the new piece of hardie board is just as simple as the demo. The article details just how the old fiber cement siding was removed with minimum damage.

Score down the damaged lap siding with a utility knife. This article describes why owners decided to remove fiber cement siding from their home and to replace it with james hardie s hardieplank fiber cement product. Face nail the top. This can happen again after caulking.

Remove any nails from the top piece of good siding. When siding shrinks it causes a gap to form between the planks. Place the flat. Remove any nails that still might be underneath the bottom portion of the piece above the one you removed.