How To Replace Bottom Piece Of Vinyl Siding

Slip the hook of the zip tool into the joint between the damaged piece and the piece above it.

How to replace bottom piece of vinyl siding.

At the bottoms of windows install under sill trim for horizontal siding and j channel trim for vertical siding. How to replace one piece of vinyl siding 1. The vinyl siding zip tool will save you loads of time. Use framing square and utility knife to cut through face of siding.

If it remains stuck double check to see if. Nail the side pieces every 12 inches placing the top nail at the top of the nailing slot and all other nails in the center of the nailing slot. You will actually start by pulling the bottom of the second course out of the top of the first course. The nails for the first course will be accessible now.

You will need to remove the bottom course of siding with your removal tool. If the piece still seems attached to the wall gently pull it outward so it comes free of the channel holding it in. Remove the nails and the piece of siding. If the siding is hard to remove try tapping it with the palm of your hand.

Starting at one end of the damaged piece push the end of the zip siding removal tool up under the siding until you feel it hook the bottom lip. If the top is mitered miter the sides as well. Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it. 15 minute vinyl siding repair with a zip tool.

Cut piece of faded siding from an inconspicuous spot to replace the damaged section. Hold the loose undamaged piece of vinyl up and out of the way with one hand. With the other use the claw end of a.