How To Replace Electric Awning Motor

You will need pop rivets reinstall the end cap.

How to replace electric awning motor.

Unscrew the panel box and access the point where it makes the connection. You have to connect back the wiring connection at the awing wiring and coach wiring before you do this step otherwise you wont have the voltage. Get it as soon as sat sep 19. Aecojoy 10 8 patio awning retractable sun shade awning cover outdoor patio canopy sunsetter deck awnings with manual crank handle beige.

Be sure to apply tape before sliding the awning off the rv. Free shipping by amazon. Loosen the bolts holding it in place and lift it out of the housing. This should be done in a retracted position.

Loosen the roller end bracket securing bolts and remove the bracket from the torsion bar by sliding it to the left end of the bar. Unbolt the chain from the drive shaft of the awning motor. The dual connector three bolt system was engineered with minimal components for fast user friendly installation saving you time and money from taking your rv or camper into the shop. You may have to rotate the motor slightly to get the gears to line up and then rotate it back in place to line up the bolt holes.

You will possibility need two ladders. This will make sure they don t scratch the side of the rv. After your awning is safely on the ground remove the end cap. With the solera power awning replacement motor your awning will be operating as usual in no time.

4 6 out of 5 stars 34. Install a new motor and tighten the bolts. Remove the bad motor and replace it with the new one. Drill out the rivets holding the end of the cap on the end of the roller.

Get to the motor using a ladder and open it up. Best seller in patio awnings. Remove the connection and test the voltage at that point. Carefree r001326wht white rv travel r electric awning replacement motor.

Remove the awning from the mounting bracket and lay it safely on the ground. Replace electric awning fabric. Pull out the motor unplug the wire plug in the new motor and reverse everything. Cover the upper awning brackets with electrical tape or masking tape.