How To Replace Siding On An Rv

Pop any dents out of the aluminum siding by first drilling a 1 8 inch hole in the center of the dent with a power drill.

How to replace siding on an rv.

Begin by removing any lights that are installed that may be in the way of the siding. Pry open the light lens and unscrew the. There is one way to repair a dent in your aluminum before replacing the damaged panel. Generally when you need a patch to your your rv siding it is easier to just replace that damaged section if your siding is aluminum.

Remove all the frames covering the section you are about to replace then use a flathead screwdriver and remove any lights on those sections continue to use the flathead screwdriver and start removing any staples on or surrounding those. Take care not to dent or mark the undamaged panels. There is probably less work in replacing the damaged section than there is trying to repair it. Grab the washer with pliers and pull to remove the dent.

Straighten out the folded metal using a putty knife and hammer. Take a flathead screwdriver and remove all the lights on the siding. If you are reviving your old rv or just got a new one that needs some work here is a quick guide that can help you through the siding process. Step 1 remove lights.

Remove the staples holding the rv siding metal on depending on the construction used the sheet metal may be folded over and stapled from the side over the back or from the back over the side metal. How to replace rv siding step 1. Typically a flat head or other type of screwdriver can remove them. Attach a washer to the end of a 1 inch self tapping screw and then insert the screw into the drilled hole.

Move to the side and remove the staples.