How To Stagger Vinyl Siding

If you don t cut your siding short when it expands in the summer it s going to buckle.

How to stagger vinyl siding.

Using a snap lock punch punch the vinyl siding along the cut edge every 6 152mm so the raised lug is on the outside. Some will stair step it others alternate the lap up the wall. Lay out the panels required for the first course along the house. If it doesn t work for that row save it.

You need to leave at least 1 4. Different siders do it different. Siding boards usually come in uniform lengths so the best way to achieve a random stagger pattern is to cut the first board of each row a different length before installing it. Position a nail at the top of the upper slot on both sides of the corner post leaving a gap of approximately 1 32 0 8mm between the nail heads and the corner posts.

Install the second panel so that it overlaps. A properly done seam will help keep harmful moisture out and increase the insulation of your home. How to stagger vinyl siding joints 1. The siding laps should be staggered.

Everything is great except i did not stagger the panels. Push the siding into the utility trim or. Do you stagger the panels for aesthitic reasons or is there a. The starter strip is level.

Place the corner post in position allowing a 1 4 6 4mm gap between the top of the post and the eave or soffit. As long as you are staggering them according to recommended specs it really does not matter what others are doing. I installed vinyl siding on one side of my house. In vinyl and aluminum siding it s the point that allows for expansion and contraction.

I have a line straight down the center showing where each of the panels overlap. In most other siding options the seams are a point of sealant. Install the first panel by pushing the panel s buttlock up into the locking tab on the starter strip. When cutting vinyl siding it s usually to go into a corner.

Eaves treatment measure from the soffit to the base of the upper lock on the previous course. Whatever your measurement is take at least 1 4 or 1 8 on both sides for the panel to slide back and forth. With time you will figure out what looks good and does not waste anymore material then needed. Cut the panels to length with tin snips.

You can often get great stagger patterns by using the off cut from a row you just finished to start the next one. The nails are in but not to tight.