How To Tie A New Roof Patio Into Existing House

Using two inch by four inch studs build a frame for columns that stand from the porch floor to the soon to be built roof.

How to tie a new roof patio into existing house.

A house attached patio roof takes advantage of the house s structure by supporting one end of the roof on a ledger mounted horizontally to the house. Locating and mounting the ledger is normally a fairly easy process. Make sure the 2x4 joists are turned so the boards narrow edge faces the floor of the porch. The ledger typically a 2 by 6 is usually designed to hold one end of the patio roof rafters.

After that to make it flush with the roof of the existing house cut the two outer rafters. You have to do it thoroughly so that the rafters sit flush on it. Never alter engineered trusses without the approval of a licensed professional engineer. Brace the column frame in place using l brackets and concrete screws.

Adding a patio roof to your existing home can create a nice look that effortlessly flows out from your home s roof. I think i would set the frame work that the rafters will sit on then set up four of the common rafters and run the ridge board to where it will sit on the house or pull a string level across to find the point at which the ridge meets the roof. Install the 2x4 joists with some screws and brackets to the house edge. The ledger should be attached before the foundation is built for a deck patio roof posts and other structure.

Attach the horizontal beam by using a nail gun. How to attach a patio roof to an existing house. Each 2x4 joist should extend across the frame by going from the house edge to the porch edge. How to tie a additions roof to existing roof roof designs to attach to existing home how to construct a roof from an exsisting shead how to attach a deck roof to existing roof how to add a roof over porch cost to tie into existing roof attache porch roof on house attach shed roof to house adding a roof to screened in porch adding a roof to existing.

Cover the column frame with siding brick or any outdoor material that matches the exterior of your home. To tie the design together peter chose to cut the rafter tails off the extend the exterior wall up to the underside of the new roof. From the we hope this is obvious desk. Tying a patio roof into existing house.

The edge of the roof of the house and the frame to the porch should be seamless now.