This is a long video but it will show you how to do it.
How to redo a rubber roof.
How to remove repair and install a flat roof.
And tie it into your hip roof.
Allow three inches of material to extend over the edges.
Power wire brush or aggressively scrub with a plastic scrub pad or sandpaper all surfaces where the old caulking was.
Scrape away all existing patching materials and caulking.
Use warm water to sponge the surface clean then let it dry.
Cut the material to length with a utility knife.
Apply duct tape along the width and along the length.
Use a razor knife to cut out old silicone caulking.
It was time for a new coat on our rubber roof.
In order to restore the gloss you first must clean your roof thoroughly.
Unroll the membrane over the roof into the proper position.
In order to get the best results the surface must be free from any oil or grease.
Make sure you offset yo.
Make sure the sheet does not have creases or wrinkles.
Allow 15 to 30 minutes depending on the weather for the material to relax.