Most tarps have grommets that will allow you to tie off the tarp to your roof.
How to tarp a roof without nails.
Screw the 2 by 4 directly into the roof to secure it.
Installing a tarp on your roof is easier than you think.
The board must be 2 feet longer than the tarp s width and it should sit against the roof to avoid the collection of rainwater snow or debris.
Place the 2 4 against the roof along the rake to prevent water collection.
Roll the tarp over the damaged area taking care that it extends at least 3 on all sides.
Installing tarp on a roof without nails.
Don t simply nail into the tarp.
Find the source of the leak.
Next on the peak side attach the tarp to the 2 by 4 using cap nails.
You may need to put nails in or around your soffit area to tie off the ropes and tarp.
Your 2 4 should be two feet longer than the width of your tarp.
How can can i use a tarp on a metal roof without the the nail put a hole in my shingles.
The 2 by 4 should be about 2 feet longer than the tarp width.
Thomas boni july 8 2018 at 3 29 pm.
Wrap your tarp around the board then secure the board to the roof with a screw.
Then fold the excess tarp under a few rotations for a tight clean fit.
Nail the tarp to the fascia board over the edge of.
Time wind and rain will eventually pull those nails right through the tarp if you don t use wood and you ll have a flapping tarp on your roof doing nobody any good.
Once you re on the roof and ready to rock and roll spread out your tarp to the coverage you want.
Pull the tarp tight and smooth out wrinkles.
Next install furring strips to the parallel bottom side of the tarp.
If your tarp is too.
Lay the tarp out flat over the roof.
Continue along the length of the ridge line.
Extend the top edge of the tarp over the roof.
Let the rest of the tarp hang off the lower border of the roof that overhangs the wall known as the eave.
These nails should be placed 12 to 18 apart.
It s even easier if you do it without nails.
Here are the steps on how to install a tarp on your roof without nails.
Make sure to tighten the tarp as much as possible to the structure.
Create an anchor board by rolling the tarp s peak end with a 2 x 4 inch board and nailing the tarp to your board with your 3 inch nails.
Place the plywood or sheet metal over the hole and use roofing nails and a hammer or decking screws and a cordless drill to secure the plywood to the roof.
Lay the tarp across the roof so that at least 4 feet 1 2 m lies on the sloped part of your roof on each side known as the peak.
Using nails attach the peak end of your tarp to a 2 4.
